Pi-Star cross modes: Revisions

CC BY-SA = open in new tab ]

May 27, 2019

Revised WiresX Passthrough option

Revised (YSF2DMR) CCS7/DMR ID option

May 21, 2019

Revised (YSF2DMR) CCS7/DMR ID option

May 20, 2019

Revised (YSF2DMR) CCS7/DMR ID option

May 19, 2019

Revised DMR cross-mode configuration opening paragraph

To use the optional DMR2### cross-mode capability (requires Pi-Star 3.4.14 or later), in the MMDVMHost Configuration settings, enable both the DMR and DMR2### mode you want to use (you must disable the YSF or NXDN direct mode, as well as other cross modes, and normally you also should disable the other direct modes). After you have applied changes, you'll see both the Configuration modules for DMR and the other mode you selected.

Revised DMR2YSF section

Updated screen image.

Deleted APRS Host bullet point. This option has been moved to General Configuration.

Revised YSF cross-mode configuration section

Updated screen image.

Revised opening paragraph:
To use the optional YSF2### cross-mode capability (requires Pi-Star 3.4.10 or later), in the MMDVMHost Configuration settings, enable both the YSF and YSF2### modes you want to use (you must disable the DMR, NXDN, or P25 direct mode, as well as other non-YSF cross modes, and normally you also should disable the other direct modes), and then set up as follows.

Revised (YSF2DMR) CCS7/DMR ID option